Influence analysis of cracking strength and interaction of hydraulic pressure tunnel lining
LIU Lipeng1, WANG Yanbing2, SONG Qian3
1. China Institute of Water Resources and Hydropower Research, Beijing 100048, China; 2. State Grid Economic and Technological Research Institite Co., Ltd., Beijing 102209, China; 3. State Grid Corporation of China, Beijing 100031, China
Abstract: Using the numerical simulation model, the effects of the surrounding rock deformation capacity, lining concrete label, backfill grouting pressure, and grouting stone deformation capacity on the hydraulic head of the hydraulic pressure tunnel lining and the joint bearing ratio of the surrounding rock and lining were analyzed. The result showed that: the elastic modulus of the surrounding rock had a significant effect on the joint bearing ratio of the surrounding rock and the lining. When the higher the elastic modulus of the rock mass, the greater the load shared. The effect of the lining concrete label and the grouting stones was small, and the backfill grouting pressure had no effect basically. The modulus of surrounding rock and grouting stones, grouting pressure increased, and the internal water head required for lining cracking increased. The influence of elastic modulus of surrounding rock and backfill grouting on cracking head was more obvious, but due to the concrete rank increase, the lining load sharing ratio increased, and the lining cracking head gradually decreased. The research results could provide support for the design of hydraulic pressure tunnel lining and the reasonable selection of grouting parameters.
刘立鹏,王彦兵,宋倩. 水工有压隧洞衬砌启裂水头及围岩联合承载影响分析[J]. 隧道与地下工程灾害防治, 2020, 2(4): 52-58.
LIU Lipeng, WANG Yanbing, SONG Qian. Influence analysis of cracking strength and interaction of hydraulic pressure tunnel lining. Hazard Control in Tunnelling and Underground Engineering, 2020, 2(4): 52-58.
[1] 张有天. 水工隧洞建设的经验和教训(上)[J]. 贵州水力发电, 2001, 15(4): 76-84. [2] 徐光亮. 渔子溪一级电站引水隧洞放空检查情况[J]. 水力发电, 1982(6): 29-30. [3] 王均星,陈晓勇,尹浩,等. 湖南镇水电站水工模型试验研究[J].水力发电学报,2008, 27(5): 103-108. WANG Junxing, CHEN Xiaoyong, YING Hao, et al. Study on the hydraulic model tests of Hu'nanzhen hydropower station[J]. Journal of Hydroelectric Engineering, 2008, 27(5): 103-108. [4] 朱介澍.西洱河一级水电站引水隧洞喷锚衬砌及不衬砌段的设计[J].水力发电, 1981(2): 27-31. [5] 徐少国, 宋玉波, 徐庭馨.察尔森泄洪发电洞漏水分析及加固措施[J].东北水利水电, 2015, 33(12): 51-53. [6] 姜允松.广蓄电站砼衬砌式高压岔管模拟试验与定性分析[J].云南水力发电, 1995(2): 60-67. [7] 叶冀升.广蓄电站钢筋混凝土衬砌岔管建设的几点经验[J].水力发电学报, 2001(2): 93-105. [8] 肖阳,马震岳. 水工压力隧洞设计与计算方法研究[J]. 水电能源科学, 2004, 22(2):76-78. XIAO Yang, MA Zhenyue. Study of design and calculation of hydraulic pressure tunnel[J]. Water Resources and Power, 2004, 22(2):76-78. [9] 杨晓娟, 漆文邦, 郑俊, 等. 中小型水电站非圆形有压隧洞衬砌配筋计算[J]. 水力发电, 2012, 38(1): 27-29.. YANG Xiaojuan, QI Wenbang, ZHENG Jun, et al. Lining reinforcement calculation of non-circular pressure tunnel in small and medium hydropower station[J]. Water Power, 2012, 38(1): 27-29. [10] 汪基伟, 冷飞, 蒋勇. 圆形压力隧洞限裂配筋设计方法研究[J]. 土木工程学报, 2011, 44(10): 143-148. WANG Jiwei, LENG Fei, JIANG Yong. Study of reinforcement design by crack width control for circular pressure tunnels[J]. China Civil Engineering Journal, 2011, 44(10): 143-148. [11] 李宁, 刘波. 城门洞型压力隧洞衬砌限裂配筋设计方法研究[J]. 岩石力学与工程学报, 2013, 32(12): 2409-2414. LI Ning, LIU Bo. Research on lining reinforcement design method by crack width control for rectangular pressure tunnel with arch crown[J]. Chinese Journal of Rock Mechanics and Engineering, 2013, 32(12): 2409-2414. [12] SOLTANI A, HARRIES K A, SHAHROOZ B M. Crack opening behavior of concrete reinforced with high strength reinforcing steel[J]. International Journal of Concrete Structures and Materials, 2013, 7(4):253-264. [13] 李扬, 侯建国. 美国混凝土结构设计规范ACI 318的裂缝控制设计方法浅析[J].武汉大学学报(工学版), 2008, 41(增刊1): 61-64. LI Yang, HOU Jianguo. Simple analysis of design method of flexural crack control in American design standard of concrete structures ACI 318[J]. Engineering Journal of Wuhan University, 2008, 41(Suppl.1): 61-64. [14] SIMANJUNTAK T D Y F, MARENCE M, MYNETT A E, et al. Mechanical-hydraulic interaction in the lining cracking process of pressure tunnels[J]. International Journal on Hydropower & Dams, 2013, 20(3):48-54. [15] 章鹏, 潘定才, 郑晶星. 抽水蓄能电站高压水道钢筋混凝土衬砌技术特点[J]. 水力发电, 2017, 43(11): 23-26. ZHANG Peng, PAN Dingcai, ZHENG Jingxing. Technical characteristics of reinforced concrete lining for high pressure hydropower tunnel of pumped-storage power Station[J]. Water Power, 2017, 43(11): 23-26.
2020, Vol. 2 
